View and Download Kawasaki Ninja R service manual online. Ninja R Motorcycle pdf manual download. Also for: Ninja er-6f, Ninja er-6f abs. Visit Kawasaki Motor Corps., USA owners center for up to date service manuals, parts diagrams, ROK™ info, owner support, warranty info, Kawasaki Protection. Ninja R. ER-6f. ER-6f ABS. Motorcycle. Service Manual. All rights reserved. No parts of this publication may be reproduced, stored in a retrieval system, or.
|Published (Last):||22 August 2013|
|PDF File Size:||19.75 Mb|
|ePub File Size:||16.72 Mb|
|Price:||Free* [*Free Regsitration Required]|
2007 Kawasaki Ninja 650R — Owner’s Manual
Special Tools and Sealant Hand Tester: Oxygen Sensor Equipped Models If the engine cannot be started, the self-diagnosis system does not detect dynamic condi- tion of the crankshaft sensor. Inlet air temperature sensor trouble Inspect see chapter 3. Connect the connectors securely.
Throttle Full Open UR: Also, replace the friction plates if their tangs are damaged.
Owner’s Manuals & Service Manuals | Kawasaki Vehicles
Never drop the throttle body assy, especially on a hard surface. If the corrugated fins [A] are deformed, carefully straighten them.
oners Needle Bearing Owers, ABS Hydraulic Unit Comments to this Manuals Your Name. Toothed Washer, 34 mm 1. Torque – Water Pump Cover Bolts: Insert the clamp into the frame from the air cleaner side. Air Switching Valve 2. Front Brake Hose 7. First turn the cap counterclockwise to the first stop.
Got it, continue to print. Do not use fluid from a container that has been left unsealed or that has been open for a long time.
Don’t have an account? Battery 12 V 10 Ah 4. Therefore, it should be handled carefully, never struck sharply, as with a hammer, or allowed to fall on a hard surface. Fuel Tank Bracket 4.
Battery cable making poor contact Load excessive e. Incorrect the tire pressure. Battery 12V 10 Ah 4. Torque – Grab Rail Mounting Bolts: Ignition Fuse 10 A 7. Replace any damaged gears or gears with excessively worn dogs or dog holes.
If the shift rod plate [B] was removed, install it. Ball Bearing and Needle Bearing Do not remove pressed ball or needle unless removal is absolutely necessary. There will be a gap [A] at the rear part of the holder after tightening.
Type Swingarm Wheel Travel mm 4. The headlight does not go on when the ignition switch and the engine stop switch are first turned on. Special Tool – Needle Adapter Set: If the seat width is within the specified range, lap the valve to the seat as described below. Re-check voltage and if less than Engine Stop Switch 3. Oxygen Sensor Equipped Rear shock adjustment too soft Front fork, rear shock absorber spring weak Battery discharged: This valve seat cutter is developed to grind the valve for repair.