8085 INTERFACING WITH 8255 PDF

Problem – Interface with microprocessor and write an assembly Subtract content of two ports by interfacing with microprocessor. The interfacing happens with the ports of the Microprocessor. The main IC’s which are to be interfaced with are: 1. PPI. 2. PIC. 3. USART. PPI: 82C55 The 82C55 is a popular interfacing component, that can interface any TTL-compatible I/O device to the microprocessor.

Author: Dozuru Faetaxe
Country: Malaysia
Language: English (Spanish)
Genre: Environment
Published (Last): 22 May 2004
Pages: 448
PDF File Size: 6.5 Mb
ePub File Size: 4.96 Mb
ISBN: 458-1-15858-627-4
Downloads: 37194
Price: Free* [*Free Regsitration Required]
Uploader: Yogis

As keyboard is having 8 rows and witn columns, only 4 scan lines are required and we can avoid external decoder to generate scan lines by selecting decoded scan keyboard mode.

The peripheral devices includes. Initialize memory pointer to point. Output with handshake 2. Input Output Interfacing Techniques.

Interfacing Types There are two types of interfacing in context of the processor. S, Thrikkakkara ; St. The external clock frequency is 2MHz.

Leave a Reply Cancel reply Your email address will not be published. Minimum Mode Configuration of Hence decoded mode is used. interfxcing

  AYURVEDA THE SCIENCE OF SELF-HEALING BY DR.VASANT LAD PDF

Memory mapped I/O interfacing with 8085 microprocessor

Send data on port A to glow G1 and G2. About Me Dhanoop Bhaskar. But the main disadvantage with this interfacing is that the microprocessor can perform only one function. Memory requires some signals to read from and write to registers. Initialize in write display RAM mode.

Interfacing with Microprocessor | Interfacing with

Other signal connections are same as in the non interrupt mode. Check whether count is 0.

Intel CPU Structure. Design a system both Software and Hardware that will cause 4 LEDs to flash 10 times when a push button switch is pressed. While executing an instruction, there is a necessity for the microprocessor to access memory frequently for reading various instruction codes and data stored in the interfaing.

Now how to select between the two devices according to the requirement? Interrupt Structure of Only lower data bus D 0 — D 7 is used as is 8-bit device. Introduction We know that a microprocessor is the CPU of a computer.

Assume address of the control word register of as 23H. In the interrupt driven mode interrupt line from is connected to the one of the interrupt input of except INTR.

  CAUTIVA Y SEDUCIDA LIS HALEY PDF

Load data to switch off LEDs. For this purpose an address decoding circuit is used. If not zero repeat.

Assume address of control word register of as 83H. Write a program to initialize in the configuration given below Sample 1: Design a microprocessor system to control traffic lights.

Intel A Programmable Peripheral Interface

The control word format of according to hardware connections is: Interface an 8 x 4 matrix keyboard to through Increment lookup table pointer. Port A provides the segment data inputs to the display and port B provides a means of selecting a display position at a time for multiplexing the displays.

Get interfacong 7 segment code. Motor is rotated by 1.

A programmable device can be set up to perform specific function by writing a code in the internal register. Due to this, motor can be excited by grounding four terminals of the two windings.